Top A

Sehr geehrte Kundschaft

Leider müssen wir Ihnen mitteilen, dass wir aufgrund der Corona-Thematik bis auf weiteres nur eingeschränkt Kunden in unserer Werkstatt empfangen können. Wir bitten um Ihr Verständnis! 

  • Bitte warten Sie im Eingangsbereich bis ein Mitarbeiter Sie in Empfang nimmt. Handdesinfektionsmittel steht dort bereit. Beachten Sie die Markierung auf dem Boden und halten Sie einen Abstand von mind. 2m zu anderen Personen ein.
  • Wenn die Türe oder der Lift verschlossen ist, kann trotzdem jemand in der Werkstatt sein, nur der Empfang ist dann nicht besetzt. Bitte läuten sie oder rufen sie an: 061 681 42 33
  • Gerne nehmen wir weiterhin ihre Instrumente zur Reparatur/Service entgegen. Leider müssen Sie mit dem Abholen ein wenig mehr Geduld haben als normal, da die Instrumente erst einmal in Quarantäne müssen, bevor wir an ihnen arbeiten dürfen.
  • Das Testen der Neuinstrumente ist wieder möglich. Bitte machen Sie vorgängig einen Termin, damit wir uns optimal vorbereiten können. Unsere Mitarbeiter werden Sie anschliessend über das weitere Vorgehen informieren. 

ÖFFNUNGSZEITEN: Montag- Freitag, 10:00 bis 16:00 oder nach Vereinbarung.

Es dürfen sich zurzeit maximal 3 Kund*innen in unseren Verkäufsräumen aufhalten. Wir bitten Sie um Ihr Verständnis.

Gerne sind wir für Sie telefonisch oder per Email erreichbar.

Mit den besten Grüssen – Bleiben Sie gesund!

Ihr Egger-Team

Dear customers,

the time as come when we can see you all again! 

As of today we are open to visitors again, however we have to set some hopefully momentary restrictions. 

We have reduced opening hours: 10:00 to 16:00, from Monday until Friday.

However it is always possible to make an appointment outside these opening hours. We can receive up to three customers at the same time and therefore we highly recommend to make an appointment, in order to not let you down if you want to visit us spontanuously.
Our safety instructions regarding are presentend in German, English and French at our shop's entrance.

Best regards - stay healthy!

Your Egger team

Baroque-Natural-Trumpets

In order to come as close as possible to the sound of historical instruments, we make our replicas according to traditional methods. The use of these methods produces instruments acoustically closer to original instruments, especially where tone colour is concerned.

Pitch notations refer to a´= 440 Hz. Baroque repertoire is normally performed by period instrument ensembles at a´= 415 Hz.

Models

 

HISTORIC
Instrument in brass; bell entirely hand hammered; all tubing made from hammered sheet metal with soldered seam according to historical examples; garland, sleeves and ball silver plated; the instrument is burnished by hand according to historical methods before it is polished.
MDC
Instrument in brass; bell entirely hand hammered; all tubing made from hammered “Nuremberg brass sheet metal“ with soldered seam according to historical examples; the garland is hand engraved and silver plated, while the ball and ferrules are engraved according to period examples and also silver plated; the instrument is burnished by hand according to historical methods before it is polished.

 

BAROQUE TRUMPET in D or Db

Copy after Johann Wilhelm HAAS, Nuremberg 1746
Original: previously collection Dr. E. H. Tarr, Rheinfelden, Germany
The tuning bit #V3 is necessary for all pitches and keys.

langtrompete nagel

BAROQUE TRUMPET in D or Db

Copy after Johann Leonhard EHE II, Nuremberg 1746
Original: Germanisches Nationalmuseum, Nuremberg
The tuning bit #V3 is necessary for all pitches and keys.

barocktrompete ehe
BAROQUE TRUMPET in D or Db – HAAS & EHE
Component PartCurrencyPrice

Instrument in D – Historic


Two tuning bits recommended		 CHF 3.160,-

Instrument in D – MDC


Two tuning bits recommended		 CHF 3.985,-
1 Tuning bit #V3 CHF 45,-
1 Tuning bit #V3 – MDC CHF 95,-
2 Bits for fine tuning x 45.— CHF 90,-
2 Bits for fine tuning – MDC x 95.— CHF 190,-
Db Tuning
Semitone bit – Historic		 CHF 180,-
Semitone bit – MDC CHF 225,-
C Tuning
Whole tone crook – Historic		 CHF 485,-
Whole tone crook – MDC CHF 585,-
Cb Tuning
1½ tone (minor third) crook – Historic		 CHF 485,-
1½ tone (minor third) crook – MDC CHF 585,-
The 1½ tone crook and the semitone bit are required to play the D instrument in B440.
The 1½ tone crook and the whole tone crook are needed to play the D instrument in B415. 		   
     

Instrument in Db – Historic


Two tuning bits recommended		 CHF 3.160,-

Instrument in Db – MDC


Two tuning bits recommended		 CHF 3.985,-
1 Tuning bit #V3 CHF 45,-
1 Tuning bit #V3– MDC CHF 45,-
2 Bits for fine tuning x 45.— CHF 90,-
2 Bits for fine Tuning – MDC x 95.— CHF 190,-
C Tuning
Semitone bit		 CHF 180,-
Semitone bit – MDC CHF 255,-
Cb Tuning
Whole tone crook		 CHF 485,-
Whole tone crook – MDC CHF 585,-

ACCESSORIES FOR NATURAL TRUMPETS in D or Db

Lengthening and Tuning Bits

Lengthening and Tuning Bits
Component PartCurrencyPrice
Mouthpiece shanks (available in three lengths: 73, 77, and 81 mm) CHF 170,-
Tuning bit #V1: 38 mm, for approx. 10 cent CHF 45,-
Tuning bit #V1: 38 mm, for approx. 10 cent, MDC CHF 95,-
Tuning bit #V2: 55 mm, for approx. 20 cent CHF 45,-
Tuning bit #V2: 55 mm, for approx. 20 cent, MDC CHF 95,-
Tuning bit #V3, 75 mm, for approx. 40 cents CHF 45,-
Tuning bit #V3: 75 mm, for approx. 40 cent, MDC CHF 95,-
Lengthening bit #4 CHF 50,-
Lengthening bit #4, MDC CHF 100,-
Lengthening bit #5 CHF 50,-
Lengthening bit #5, MDC CHF 100,-
Lengthening bit #6 CHF 50,-
Lengthening bit #6, MDC CHF 105,-
Lengthening bit #7 CHF 50,-
Lengthening bit #7, MDC CHF 105,-
 

Four-Hole Option for Natural Trumpets, Standard Quality

Four-Hole Option for Natural Trumpets, Standard Quality
Component PartCurrencyPrice
*Only the instrument originally built in D can use the D 4-hole yard. The Db instrument cannot be shortened using this yard.
D 4-hole yard* (bows are the same as for the no-hole version) CHF 115,-
2 adaptors for 4-hole yards, in D CHF 160,-
Db 4-hole yard CHF 115,-
Db bow for the Db yard* CHF 295,-
C 4-hole yard CHF 115,-
C crook for the C yard* CHF 380,-
Cb 4-hole yard CHF 115,-
Cb crook for the Cb yard, leadpipe* CHF 380,-
1 adaptor for 4-hole yards, in Db/C/Cb CHF 80,-
Leadpipe for Db/C/Cb CHF 125,-
 

Other accessories

Other accessories
Component PartCurrencyPrice
Extra bow with one hole and screw – Historic CHF 385,-
Extra bow with one hole and screw – MDC CHF 475,-
Further holes with screws CHF 35,-
Slide CHF 570,-
Slide adapter CHF 110,-
Historical mute CHF 130,-
 

Gig Bags and Cases

Gig Bags and Cases
Component PartCurrencyPrice
Gig Bag for two long (natural or 4-hole) trumpets CHF 295,-
Case for one natural trumpet CHF 215,-
Case for two long trumpets (or long and short form trumpet) CHF 330,-

April 2015